AT-VME-PMC-CAR
- VME PMC Carrier Card – 6U size, single slot
- Fully compliant to VME64x standard
- Supports 3.3V PCI signaling
- Compliant to IEEE P1386.1 Specifications
- Board uses 3.3V and 5V derived from Backplane power supply unit
- PCI-Bus 64 bit, 33MHz/66MHz
- VME A32/A24/A16 Master and Slave Addressing
- User I/O Routing
- LED indicators to indicate the Power-on condition
- Easily configured with any combination of PMC Modules
- Combine different interface types and functions on one VME card
The AT’s VME-PMC-CAR is a single slot, double height (6U) VME64x, extended VMEbus module with two separate PMC slots. The VME-PMC-CAR uses an on board, industry standard, Tundra chip (Tsi148) providing the bridge between the VMEbus and PCIbus. The VME-PMC-CAR fulfils the requirements of the VME64x extension plus the Interface for Rear I/O. Each PMC-slot is in conformance with the Draft Standard Physical and Environmental Layers for PCI Mezzanine Cards (P1386.1). The card comes standard with easy to read front panel configuration displays, and two single width PMC slots. The VME PMC carrier allows the user to build powerful and cost effective VME systems by increasing board density.
The VME-PMC-CAR is designed to plug all standard PMC modules with a maximum PCIbus width of 64bit operating at 66MHz. The VME-PMC-CAR carrier board supports the +3.3V PCIbus signaling, hence only +3.3V tolerant devices may be used.
General
- VME64x bus Interface
- PCI bus Interface: Fully PCI 2.1 Compliant, 3.3V Signaling
- Form Factor: 6U size
- PMC slots compliant to IEEE P1386.1 specifications
VME to PCI Bridge
- High performance 32bit VME interface
- Fully compliant with PCI Standard (Revision 2.1)
- VME master and slave capability
- PCI master and slave capability
- Full VMEbus system controller functionality
PCI Bus
- Provides the connection between the PMC interfaces to the VMEbus Interface
- Fully compliant to PCIbus Specification Rev 2.2
- PCIbus width of 64 bit
- PCI bus operation of 33MHz/66MHz
PMC Slot
- Each PMC slot provides 64bit, 66MHz PCIbus operation
- Each PMC slot provides the capability for Rear-I/O (VME64x Mapping) Key
Front Panel
- The Front panel provides two breakouts for using the standard PMC- front panel bezel
Physical
- Single VME64x slot
- VME 6U form factor – 233 mm X 160 mm
Environmental Temperature Range
A | B | C | + | |
1 | ||||
2 | Air-Cooled | Conduction-Cooled | ||
3 | Operating Temperature | 0ºC to + 60ºC | -40ºC to + 85ºC | |
+ |
- Relative Humidity: 5% to 90% (non-condensing)
Input-Output
- 64 I/O signals of PMC slot 1 routed to VME P0 connector
- 64 I/O signals of PMC slot 2 are routed to row A and row C of VME P2 connector
Electrical Specification
- Board uses 3.3V and 5V derived from Backplane power supply unit
Warranty
- 1 year limited warranty